• 欢迎进入深圳市东方慧通化工科技有限公司官网!
    热线电话:0755-85207605  手机:18319052829招商加盟|联系我们

    产品中心

    Product Center
    水性外墙透明防水

    英文名: Transparent waterproof of water-based exterior wall

    规格:4KG、16KG、1KG

    多功能配方:

    Multifunctional formula

    优异耐候性

    Excellent weather resistance

    防水性能强

    Strong waterproof performance

    高粘接力

    High viscosity relay

    产品说明


    产品介绍:

    本品是一种多功能外墙墙面防水胶,水性配方,环保节能,采用优质高分子原料制造,具有优异耐候性能。用于墙面防潮、防水的处理。能在墙面形成一层密实的透明防水保护层,有效保护墙面不受侵蚀,同时也不影响原有饰面的优点。
    适用范围:使用于外墙乳胶漆、瓷砖、马赛克、石板、及水泥等墙面。均可使用。
    墙面处理:预涂墙面表面必须结实,干净,没有油污。PH值<10,干燥无发霉现象,使用前请彻底清除有任何粉化或松脱的外层。有明显空隙须修补抹平,新界面的混凝土应干固后方可施工。
    施工方法:可滚涂、刷涂、喷涂于预涂墙面,不兑水直接使用,使用前充分搅拌均匀,涂刷2遍或以上。
    施工条件:施工时墙面温度+6℃至35℃,相对湿度﹤85%,并在晴天通风环境中进行施工。完工后自然干燥24小时。
    技术参数:

    颜色

    白色

    状态

    液态

    PH值

    约8

    表干

    1-2小时

    理论用量

    不兑水涂刷1遍约4-6㎡/kg

    注:以上数据仅供参考,表干时间,因各地施工环境不同,而有所差异。实际涂刷面积视墙面细孔的吸收性而定,防水干燥后呈透明色。

    储存条件:请密闭存放于+6℃至35℃的干燥通风环境,避免阳光照射。

    保 质 期:24个月

    生产日期:见包装标注

    执行标准:JC/T864-2008(I)

    注意事项:

      如施工时发现异常现象,请立即停止施工,并咨询销售商以取得技术支持。

      外墙施工时,请留意天气情况。

      避免与皮肤接触,如不慎入眼,立刻用大量清水清洗,如需要请即就医。

      请妥善保管,切勿放置在儿童能够接触到的地方。

     

    Product introduction:

    This product is a multi-functional wall waterproof adhesive, water-based formula, environmental protection and energy saving, made of high-quality polymer materials, with excellent weather resistance. It is used for the treatment of wall moisture-proof and waterproof. It can form a dense transparent waterproof protective layer on the wall, effectively protect the wall from erosion, and at the same time, it does not affect the advantages of the original facing.

    Scope of application: It can be used in exterior wall emulsion paint, ceramic tile, mosaic, slate, cement and other walls.

    Wall treatment: The surface of the pre coated wall must be firm, clean and free of oil stain. PH value < 10, dry without mildew, please thoroughly remove any powdered or loose outer layer before use. If there is obvious gap, it shall be repaired and troweled, and the concrete of the new interface shall be dried and fixed before construction.

    Construction method: It can be rolled, brushed or sprayed on the pre coated wall surface. It can be directly used without mixing water. Before use, it should be fully stirred and brushed twice or more.

    Construction conditions: During construction, the wall temperature is + 6 ℃ to 35 ℃, the relative humidity is less than 85%, and the construction is carried out in a sunny ventilation environment. Dry for 24 hours after completion.

    Technical parameters:

    colour

    white

    state

    liquid   state

    PH   value

    About   8

    Surface   dry

    1-2   hours

    Theoretical   dosage

    Brush   once without water, about 4-6m2 / kg

    Note: The above data is for reference only. The table drying time varies with different construction environments. The actual painting area depends on the absorption of the fine holes on the wall, which will be transparent after being waterproof and dry.

    Storage conditions: Please store in a dry and ventilated environment of + 6 ℃ to 35 ℃ to avoid sunlight.

    quality guarantee period: 24 months

    date of manufacture: See package label

    Executive standard: JC/T864-2008(I)

    matters needing attention:

    1.    If any abnormal phenomenon is found during the construction, please stop the construction immediately and consult the seller for technical support.

    2.    Please pay attention to the weather when constructing the exterior wall.

    3.    Avoid contact with the skin. If it enters the eye, wash it immediately with plenty of water. If necessary, please see a doctor.

    4.    Please take good care of it and do not put it in a place where children can touch it.

     

    必赢